|
How long does it take to
set up the Aqua Deck?
It takes about one
hour to set up the Aqua Deck for the first time, quicker if there are
several people to help or if you've stored the trampoline fully
assembled.
|
How do you inflate the Aqua Deck tube?
We highly
recommend using an industrial inflator / deflator like the RAVE
Hurricane Blower. With this blower, it only takes about 10 minutes
to inflate the Aqua Deck tube, depending on the tube size. You can order
this high volume inflator / deflator directly from RAVE Sports by
calling 800-659-0790. Using the air output side of a shop vacuum is also
an effective way of swiftly inflating the tube, since shop vacuums
typically have high air flow rates.
|
Can I
use an Air Compressor to inflate the tube?
We do not
recommend the use of an air compressor as over inflation can damage the
tube. RAVE’s commercial grade products are fully inflated with only 1-2
PSI of air pressure. The high pressure output of most air compressors
can easily cause over inflation if not monitored properly during the
inflation process. If a compressor is used, be sure not to exceed 2 PSI
within the tube.
|
How do
you deflate the Aqua Deck tube?
Again, you can use
the RAVE Sports Hurricane inflator / deflator or a shop vacuum,
positioned in reverse, to swiftly deflate the tube. Another option is to
lock the valve open on the tube and let the air naturally flow out of
the large opening of the valve.
|
What
is the tube made of?
The tube material is the same high-grade material used in many
ocean-going inflatables and inflatable military boats. It’s a 1000
Denier Polyester with 22 oz. UV treated PVC. All seams are heat-welded
for maximum strength and doubled at key stress points. We don not use
natural rubber or natural rubber latex in any of our products.
Therefore, people with allergic reactions to latex should not have any
problems using our products.
|
Can
the Aqua Deck be used in salt water?
Yes, the Aqua Deck
can be used in the ocean and other salt water locations. In addition to
the UV-treated material, the Aqua Deck’s springs, V-rings and tramp
frame are made from heavy gauge, hot dipped galvanized steel. Because of
the salt-water environment, springs may need to be replaced more
frequently. Stainless steel components are also used where practical.
|
Will
the Aqua Deck fade in the sun?
The tube will
retain its brilliance for years because UV inhibitors are specially
blended into the chemistry of our PVC materials. We also recommend using
303 Aerospace Protectant as a secondary topical agent (like sunscreen
for your skin) to prevent fading and degradation. 303 also restores lost
color and luster, making your Aqua Deck vinyl look like new. Periodic
(monthly) application of 303 protectant will provide the best results.
|
Can the Aqua
Deck be left out in the water?
Most people leave
their Aqua Deck in the water for the season. There are two things to
consider: 1) your local regulations regarding anchoring and 2) if the
area is consistently exposed to high winds. In those parts of the world
where the water never freezes, the Aqua Deck can be left in all year.
|
How deep does the water need
to be to use the Aqua Deck?
You should anchor
your Aqua Deck in at least 10 feet of water in an area at least 30 feet
from any docks, boats or other obstructions.
|
How do you anchor the Aqua
Deck?
Sufficient
anchoring methods will vary depending on your local conditions (ex.
Water depth, type of water bottom, exposure to high winds or water
current, etc.). Please consult with local authorities (ie. Dock and lift
dealerships, marinas or your local water enforcement officials) to
understand proven anchoring methods or anchoring restrictions in your
area. A heavy duty harness is included with your Aqua Deck. The
anchoring method you select should attach to the swivel ring on this
harness.
|
-
We recommend using a shock cord as a part of the anchor line to help
absorb vertical movements of the Aqua Deck due to waves and normal
use. An Anchor Connecting System is available directly from RAVE
Sports which includes this shock cord. Call 800-659-0790 for more
information
-
Choose a location
most protected from wind and water currents.
-
A
minimum of 60 lbs. of anchor weight is recommended for most
applications. However, Aqua Decks on larger bodies of water may
require more.
-
Bell anchors are not recommended since they are easily dragged,
especially on firm bottoms. Multiple foundation blocks are commonly
used on soft bottoms. Screw-type or more permanent toggle-style
anchors are typically used in more extreme conditions.
-
Recommendations for anchor line length can be found in your owner
manual.
|
How do you transport the
Aqua Deck on the land and water?
You should enlist
two or three people to help you lift and carry the Aqua Deck from land
to water, and four to five people for the largest Aqua Deck. DO
NOT DRAG. RAVE doesn’t recommend towing the Aqua Deck on the
water, although it can be transported at very low speeds.
|
Can the Aqua Deck be
used as a land trampoline?
The Aqua Deck was
not designed for use on land. Like any inflatable product, the Aqua Deck
tube should not be exposed to rough edges or sharp objects like rocks
and sticks.
|
How high can you
bounce on the Aqua Deck?
The bounce height
depends on the firmness of tube inflation and weight and strength of the
bouncer. It won’t perform exactly like a land trampoline because the
water and inflated tube absorb some of the bounce. The trampoline
surface is designed so you won’t hit the water below, even with really
big bounces. Some water may splash up, however, from the wave action
caused by the tube.
|
Can you bounce
higher on the Aqua Deck or Aqua Jump?
The Aqua Deck and
Aqua Jump bounce performance is about the same, but the Aqua Jump will
accommodate more users.
|
Do you need a permit
for the Aqua Deck?
Most areas do not
require any special permits, however, you should check with your local
authorities or DNR to determine permit requirements in your area.
|
How do you repair
the Aqua Deck?
You can locate a
leak in an inflated product by spraying the tube with soapy water. When
you find the leak and determine the size of the hole, use a patch from
the repair kit and cut a swatch 1 inch wider than the hole. Deflate the
product and clean the area around the hole with rubbing alcohol. Apply
glue from the repair kit to the patch and the area around the hole. Let
the glue dry approximately 2 minutes until it becomes tacky. Stick the
glued parts to each other and rub them together using a hard, smooth,
flat surface. Let the patch dry for at least 24 hours before inflating.
For bigger holes and tears, follow the same procedure but put a patch on
the inside as well as the outside.
|
What is the warranty
on the Aqua Deck?
The Aqua Deck is
covered by a new Lifetime Warranty, while the light weight Asian
produced products like consumer towables and o-zones remain with the one
year warranty.
|
How do you maintain
and store the Aqua Deck?
To store the Aqua
Deck, you should first clean the entire inflatable with soap and water
or other mild cleansers. Do not use petroleum based or vegetable oil
based cleaners. After the tube dries, deflate the tube. Roll the tube
loosely and place in a vented container. (A large plastic storage
container (Rubbermaid or a similar brand) works well to store the tube
and keep safe from rodents). Some people prefer to keep the trampoline
frame intact and lean it against a wall instead of taking all the pieces
apart.
|
How is the Aqua Deck
different from the Aqua Jump?
The Aqua Deck and
the Aqua Jump are all made from the same high-quality materials using
many of the same components. There are a few differences, however:
-
The Aqua Deck is square, smaller and sits lower to the water.
Because of its size, the Aqua Deck may be perceived as less
visually intrusive on the water than the larger Aqua Jump units.
The Aqua Deck is a nice replacement to the traditional hard, 10’
x 10’ swim raft.
-
Because of its smaller size, the Aqua Deck is more portable and
quicker to set up and take down.
-
You cannot attach the Aqua Launch to the Aqua Deck. This
attachment only works with the Aqua Jump. The Slidewalk will
attach to the Aqua Deck as well as the Aqua Jump. If you want a
Slide or a Log attachment, then you must order the version
specifically designed to be used on the Aqua Deck.
|
With one chamber,
will the Aqua Deck sink if it gets a hole?
The Aqua Deck will
not sink if the tube is punctured. Enough air accumulates in the tube to
keep the Aqua Deck components afloat. A single air chamber also provides
even distribution of the air around the full perimeter of the product,
even if air pressure gets low.
|
Does RAVE sell
covers for the Aqua Decks?
Yes. Covers are
available for the Aqua Deck, Aqua Deck 15, Aqua Deck 20, and Aqua Deck
25 products. Please see you local RAVE dealer for more information or
visit our accessories website.
|
What can I do to
keep my product safe from muskrats, mice and other rodents?
Rodents like
muskrats may be attracted to the PVC vinyl of our product. When your
tube is on the water, maintaining full air pressure during periods of
non-use usually prevents them from being able to get a hold of the vinyl
to chew on it. However, the best way to solve the problem of nuisance
rodents is to remove the temptation by taking the product out of the
water at night. Another option is to make the whole area unattractive to
rodents by changing the environment, eliminating food sources along the
shoreline and making the area less hospitable to their inhabitance.
|